Mr Quyen - Santiago. Posted 14/11/2026

Plastic roof tiles for a conservatory usually means a lightweight tile-look roof in place of glass or polycarbonate. A Santiago ASA/PVC tile sheet reads as rows of curved tiles and weighs about 5.4 kg per m² of roof at 2.5 mm. Putting a solid roof on a conservatory is a structural change: the installer or an engineer must check or design the frame, and local building rules apply. Santiago gives no structural rating for conservatory frames.

Porch roof covered with red tile sheet, Vietnam

Porch roof covered with red tile sheet, Vietnam

 

Can you put plastic roof tiles on a conservatory?

 

Yes, on a frame that has been checked or designed for it. A conservatory frame was built for the roof it has now. A solid tile-sheet roof brings a different weight, needs purlins less than 700 mm apart to screw into (440 or 660 mm for the tile sheet, one under the foot of each 219 mm tile step), and takes wind differently from glazing. Your installer or engineer decides whether the existing frame can carry it, needs strengthening, or should be replaced. Santiago supplies the sheets and accessories; it does not install and does not rate frames.

The roof slope is the second check. The tile sheet needs 20 – 45%, which is about 11.3° to 24.2°. Many lean-to roofs are built flatter than that; below 20% the tile sheet is not recommended, because water runs off too slowly.

SlopeDegreesRise per 12
20% (minimum)11.3°2.4 in 12
25%14.0°3 in 12
30%16.7°3.6 in 12
35%19.3°4.2 in 12
45% (maximum)24.2°5.4 in 12

 

Conservatory, porch or extension: what changes in each case?

 

ProjectWhat changesWho checks
Glazed conservatory to solid roofNew roof weight, purlins, less daylight in the roomInstaller or engineer; building control or the equivalent office
Open porch or entrance canopyRoof over an entrance, often against the house wallInstaller
New single-storey extensionRoof designed from the start for tile sheet and purlinsDesigner or engineer, with the planning or building office
Lean-to against the houseJunction with the house wall needs vertical wall flashingInstaller

House extension with a red tile-sheet roof, Vietnam

House extension with a red tile-sheet roof, Vietnam

 

Do you need planning permission or building approval?

 

Rules differ by country and by local council, and changing a conservatory roof or building an extension can fall under planning rules, building regulations, or both. Ask your planning office and building control, or the office that does that job where you live, before you order anything. A good installer usually knows the local process. Match the roof to the house where you can: Santiago's five standard colours are dark grey, red, blue, orange and chocolate, and green, white and purple are made to order.

 

Will a tile-sheet roof make the room cooler and quieter?

 

Santiago's figures compare ASA/PVC with bare metal sheet: about 6 – 8 °C cooler under the roof and about 80% less rain noise. Santiago has not tested its sheet against glass or polycarbonate conservatory roofs, so we give no figure for that. What you can expect is shade: the tile sheet is opaque, so a room that had a glazed roof becomes darker. Plan windows and lighting with your installer before the roof changes, not after.

The ASA top layer showed no colour change after 2,000 hours of artificial UV, the colour is rated for 30 years, and the sheet contains no metal to rust. The warranty is 10 years for 2.5 mm and thicker sheet installed as Santiago recommends.

Side extension of a house with a tile-sheet roof, Vietnam

Side extension of a house with a tile-sheet roof, Vietnam

 

Example: tile sheet for a 3 × 4 m lean-to

 

A lean-to 4.0 m along the house wall and 3.0 m out from it, with about 0.18 m of eave overhang and 0.1 m at each side, at a 25% slope (14°). The figures are the sheet list only; the frame is the installer's design.

ItemWorkingResult
Horizontal run3.0 m + 0.18 m3.18 m
Length along the slope3.18 m × 1.031 for a 25% slopeabout 3.28 m
Sheet length3.28 m ÷ 0.219 m = 14.97, round up to 15 steps3.285 m
Roof width4.0 m + 2 × 0.1 m4.2 m
Sheets4.2 m ÷ 0.96 m = 4.4, round up; last sheet trimmed5 sheets, about 16.4 running metres
Roof area4.2 m × 3.28 mabout 13.8 m²
Purlin rows3.28 m at 660 or 440 mmabout 6 at 660 mm or 9 at 440 mm
Screw sets with ASA caps13.8 m² × 4 – 5 per m²about 55 – 70
Vertical wall flashingAlong the house wall4.2 m
Eave drip tileAlong the eave4.2 m
Sheet weight13.8 m² × 5.4 kgabout 75 kg

Fixing follows the usual rules: pre-drill 6 mm holes, drive 70 mm screws through the top of the wave over a purlin, never in the valley, cap every screw, and lap each sheet one wave over the last.

 

How do you buy tile sheets for one conservatory?

 

Santiago exports by the 40 ft container, about 5,000 m of sheet, so a single conservatory is bought through a dealer, importer or builder in your country who imports by the container. Ask them for free samples (the buyer pays the courier) and judge the colour outdoors next to your house. Prices are quoted per order in writing.

White house with an orange tile-sheet roof, Vietnam

White house with an orange tile-sheet roof, Vietnam

How do tile sheets look on a finished house roof?

Red ASA/PVC tile sheets are carried up to a house, a flame is put to a stack of sheets, and the short ends on a blue warehouse roof under installation and grey sheets on the factory roller line. A flame test is a demonstration, not a fire rating.

Santiago PVC roofing tiles in real conditions (Santiago video on YouTube).

More short videos for home extensions

Two short clips in English, filmed by Santiago. Tap a video to play it here on the page.

Why are thin roofs hot and loud in summer rain?

Mr Quyen holds a white tile sheet in the Santiago factory and explains in English, with captions, why bare metal roofs are hot, noisy in rain and costly to repair. The short then shows a red tile roof on a house and a finished grey tile roof beside the gutter.

Heat and rain noise: Santiago ASA/uPVC roofing explained (Santiago video on YouTube).

How tough is the sheet before it goes on?

Mr Quyen sets two blue sheets on the ground at the factory and a Santiago truck drives across them. It shows how tough the material is; the roof itself still needs purlins spaced less than 700 mm apart.

Truck test on Santiago ASA/PVC sheets (Santiago video on YouTube).

Santiago – a leading exporter of ASA/PVC roofing from Vietnam

Santiago roofing is produced and loaded into containers at our factory in Vietnam. It has been exported to India since 2023, Thailand since 2024 and the USA since 2025. Every export shipment comes with a commercial invoice, packing list, bill of lading and a certificate of origin (C/O) issued by Vietnam's Ministry of Industry and Trade, which importers use to claim the duty preference of their trade agreement.

ItemDetails
HS code3925.90.00 (ASA/PVC roofing sheets)
Certificate of originForm D (ASEAN), Form AI (India), Form AK / VK (Korea), Form AJ / VJ (Japan), Form VC (Chile), CPTPP proof of origin
Shipped fromVietnam, by container

Certificate of origin Form AI (ASEAN–India) for Santiago ASA/PVC roofing sheets, HS 39259000, certified on 24 September 2026. Buyer details are hidden.

Certificate of origin Form AI (ASEAN–India) for Santiago ASA/PVC roofing sheets, HS 39259000, certified on 24 September 2026. Buyer details are hidden.

The Santiago team beside a loaded export container at the factory, November 2024

The Santiago team beside a loaded export container at the factory, November 2024

Loading Santiago roof tiles into an export container

Loading Santiago roof tiles into an export container

 

Frequently asked questions

 

Can I put plastic roof tiles on my conservatory?

Only on a frame your installer or an engineer has checked or designed for a solid roof, with purlins less than 700 mm apart and a slope of 20 – 45%. Check local building rules first. Santiago gives no structural rating for conservatory frames.

 

How heavy are plastic roof tiles for a conservatory?

A 2.5 mm Santiago ASA/PVC tile sheet weighs about 5.4 kg per m² of roof, so a 3 × 4 m lean-to roof of about 13.8 m² carries about 75 kg of sheet.

 

What is the minimum pitch for plastic roof tiles?

20%, about 11.3° or 2.4 in 12. Santiago recommends 20 – 45%; below 20% the tile sheet is not recommended.

 

Will a tile-sheet roof make my conservatory darker?

Yes. The tile sheet is opaque, so plan windows and lighting with your installer before changing a glazed roof.

 

Do I need permission for a solid conservatory roof?

Rules differ by country and council. Ask your planning office and building control, or the equivalent office where you live, before ordering.

 

Read more

 

 

Sources for the figures in this article

  • Profiles, 2.5–3.0 mm thickness and 10-year warranty: Santiago ASA/PVC product specification.
  • About 6–8 °C cooler than bare metal sheet and about 80% less rain noise: Santiago's own comparisons on finished roofs in Vietnam.
  • HS code 3925.90.00: Harmonized System Chapter 39 (builders' ware of plastics), as applied in Vietnam's export tariff.
  • Certificates of origin (Form D, AI, AK/VK, AJ/VJ, VC, CPTPP): issued by Vietnam's Ministry of Industry and Trade under the country's free trade agreements.
  • Minimum order of one 40 ft container (about 5,000 m) and about 5 days for production and loading: Santiago export desk, October 2026.

Updated 03/11/2026. Santiago Import Export Co., Ltd, Vietnam. WhatsApp +84 935 391 495 (Mr. Quyen), hotline +84 965 437 316 (Mrs. Ly), email salessantiagoroofing@gmail.com.