Mr Quyen - Santiago. Posted 14/11/2026

For a carport or car porch, an ASA/PVC sheet keeps the space under it about 6 – 8 °C cooler than bare metal sheet, cuts rain noise by about 80% and has no metal to rust. Build the roof at a slope of at least 20% on purlins less than 700 mm apart, and have your builder design the posts and fixings for wind, because an open carport catches wind from below. A 6.0 × 5.5 m two-car carport takes 7 tile sheets of 5.694 m.

Red and grey roofs over a row of stalls, Vietnam

Red and grey roofs over a row of stalls, Vietnam

 

What is the best roofing sheet for car parking?

 

A parked car needs three things from the roof above it: shade, so the cabin and dashboard do not bake; dry space to get in and out in the rain; and a roof that stays sound for years over a floor that is often wet or washed. The comparison below uses Santiago's own figures for ASA/PVC and says only what is general for bare metal.

What you wantBare metal sheetASA/PVC sheet
Heat under the roofGets hot quickly in sunAbout 6 – 8 °C cooler than bare metal
Rain noiseLoudAbout 80% lower than metal
RustCut edges, scratches and screw holes can rustNo metal in the sheet
ColourDepends on the paintASA layer: no colour change after 2,000 hours of artificial UV; colour rated 30 years
Service lifeDepends on coating and site25 – 30 years in real use; 10-year warranty from 2.5 mm

Opaque sheets give full shade. If the carport is deep or joins the house and you want daylight under it, swap a few sheets for skylight sheets: they let through 80 – 90% of light and normally cover 5 – 10% of the roof area.

 

Which roofing sheets suit a carport, car shed or car porch?

 

StructureProfileWhy
Car porch at the front of a houseTile sheet, 1.05 m wide, 0.96 m coverLooks like the house roof, with ridge and edge pieces in the same colour
Carport beside the houseTile sheet or 6-wave sheetTile look near the house, plain waves for a utility look
Car shed or parking shed for several cars5-wave or 6-wave sheetWide cover per sheet, cut to the slope length
Motorbike and bicycle shelters11-wave sheetA lower 20 mm wave for small roofs

Red tile canopy over a courtyard, Vietnam

Red tile canopy over a courtyard, Vietnam

 

What slope does a carport roof need?

 

At least 20%, which many flat carport designs do not have. Below 20% rain drains too slowly and wind can push it back through the side laps. Santiago's sheets are made for slopes of 20 – 45%. A 20% slope is about 11.3°, or 2.4 in 12; 30% is about 16.7°, or 3.6 in 12.

Depth of the roof (horizontal)Rise at 20%Rise at 30%
3.0 m (about 10 ft)0.60 m0.90 m
4.5 m (about 15 ft)0.90 m1.35 m
5.5 m (about 18 ft)1.10 m1.65 m
6.0 m (about 20 ft)1.20 m1.80 m

Check the rise against the house before you build. A lean-to carport fixed to a wall needs that wall to be tall enough for the high end, and the low end still has to clear the car roof and the open boot.

 

Worked example: a two-car carport, 6.0 × 5.5 m

 

A single-slope roof 6.0 m wide, falling across the 5.5 m depth at 20%. The rise is 1.10 m, so the back posts stand 1.10 m taller than the front ones. The length along the slope is √(5.5² + 1.1²), about 5.61 m. Tile sheets are cut in 219 mm steps: 5.61 ÷ 0.219 = 25.6, rounded up to 26 steps, so each sheet is 26 × 0.219 = 5.694 m long. Add any eave overhang your installer wants before rounding.

ItemCalculationResult
Sheets across the width6.0 ÷ 0.96 = 6.257 sheets of 5.694 m
Roof area6.0 × 5.69About 34 m²
Purlin rows (tile sheet, 660 mm apart)5.69 ÷ 0.66 = 8.6 spaces, so 910 rows
Screw sets34 × 4 – 5About 140 – 170
Sheet weight34 × 5.4 kgAbout 185 kg

Seven sheets cover 6.72 m, so the extra width can become a side overhang. Send the frame drawing with your order and ask for sheet lengths, sheet count, edge pieces and screws on one written quotation.

Grey tile awnings over windows, Vietnam

Grey tile awnings over windows, Vietnam

 

How do you stop the wind lifting a carport roof?

 

A carport has open sides, so wind blows under the roof as well as over it, and that uplift pulls on every screw, purlin and post. Santiago gives no structural or wind rating, so the posts, footings, beams and fixing pattern are for your builder or engineer to design under local rules. On the roof itself, Santiago's method is the starting point:

  • Screw through the top of the wave into each purlin with 70 mm screws and ASA caps, never in the valley.
  • Use 4 – 5 screw sets per m² as the minimum; your installer adds more along the edges and ends where local rules or wind exposure call for it.
  • Pre-drill 6 mm holes so the sheet can move with heat, and stop tightening when the washer is snug.
  • Lap each sheet one wave over the next.

 

Where does the rain from a carport go?

 

All the rain on 34 m² of roof runs to the low edge. Fit a gutter there with a downpipe to a drain, not onto the driveway where the cars stand and not onto a neighbour's land. Where possible, slope a carport away from the house. If it has to fall towards the house wall, the gutter and its outlet need to be large enough for heavy rain, and that is a detail to agree with your installer.

Where the high end of a lean-to carport meets the house wall, fit vertical wall flashing along the joint so water running down the wall lands on the roof, not behind it.

 

How do you make a car porch match the house?

 

Order the porch roof in the house colour. Standard colours are dark grey, red, blue, orange and chocolate; green, white and purple are made to order, and the ridge cap, edge pieces and screw caps come in the same colours. On a carport you see the underside every time you get out of the car. The standard base layer is milky white, which makes the space under the roof brighter; a dark underside can be made to order.

The sheets are not a walking surface. Clean leaves off with a long brush from a ladder, and if someone has to go onto the roof, lay boards across the purlins first.

An installer on a blue corrugated roof, Vietnam

An installer on a blue corrugated roof, Vietnam

How tough is a 2.5 mm sheet? The truck test

A Santiago delivery truck drives over a blue ASA/PVC tile sheet and a blue corrugated sheet laid on the factory yard in Vietnam. It is a demonstration only; on a roof the sheet still needs purlins less than 700 mm apart.

Truck test on Santiago ASA/PVC sheets (Santiago video on YouTube).

More short videos for carport roofs

Both clips below come from Santiago's own YouTube channel and were filmed at the factory in Vietnam or on Santiago roofs.

How are sheets fixed to the frame?

Installers screw grey Santiago tile sheets down on a roof while Mr Quyen and a colleague walk along the finished section near the gutter. The short opens in the factory with a green sheet.

Santiago uPVC tile roofs on site (Santiago video on YouTube).

Can a worker stand on a 2.5 mm sheet on the floor?

A short factory clip: a white tile sheet takes a worker's weight on the floor, a torch is aimed at red and blue sheets, and the Santiago team lines up in front of a container.

Santiago tile sheets at the factory (Santiago video on YouTube).

Santiago – a leading exporter of ASA/PVC roofing from Vietnam

Santiago roofing is produced and loaded into containers at our factory in Vietnam. It has been exported to India since 2023, Thailand since 2024 and the USA since 2025. Every export shipment comes with a commercial invoice, packing list, bill of lading and a certificate of origin (C/O) issued by Vietnam's Ministry of Industry and Trade, which importers use to claim the duty preference of their trade agreement.

ItemDetails
HS code3925.90.00 (ASA/PVC roofing sheets)
Certificate of originForm D (ASEAN), Form AI (India), Form AK / VK (Korea), Form AJ / VJ (Japan), Form VC (Chile), CPTPP proof of origin
Shipped fromVietnam, by container

Certificate of origin Form AI (ASEAN–India) for Santiago ASA/PVC roofing sheets, HS 39259000, certified on 24 September 2026. Buyer details are hidden.

Certificate of origin Form AI (ASEAN–India) for Santiago ASA/PVC roofing sheets, HS 39259000, certified on 24 September 2026. Buyer details are hidden.

The Santiago team beside a loaded export container at the factory, November 2024

The Santiago team beside a loaded export container at the factory, November 2024

Loading Santiago roof tiles into an export container

Loading Santiago roof tiles into an export container

 

Frequently asked questions

 

What is the best roofing sheet for car parking?

One that shades the car, stays quiet in rain and does not rust over a wet floor. Santiago's ASA/PVC sheets are about 6 – 8 °C cooler underneath than bare metal sheet, about 80% quieter in rain and contain no metal.

 

What slope does a carport roof need for PVC sheets?

At least 20% (about 11.3°, or 2.4 in 12), up to 45%. A 5.5 m deep carport needs a rise of 1.10 m at 20%.

 

How many sheets does a 6.0 × 5.5 m carport need?

At a 20% slope, 7 tile sheets of 5.694 m, about 34 m² of roof, with about 140 – 170 screw sets.

 

Which roofing sheet is best for a car porch in front of a house?

The tile sheet, in the same colour as the house roof, so the porch looks like part of the house. Ridge and edge pieces come in the same colours.

 

Can I walk on a carport roof to clean it?

No. ASA/PVC sheets are not a walking surface. Use a long brush from a ladder, or lay boards across the purlins.

 

Read more

 

 

Sources for the figures in this article

  • Profiles, 2.5–3.0 mm thickness and 10-year warranty: Santiago ASA/PVC product specification.
  • About 6–8 °C cooler than bare metal sheet and about 80% less rain noise: Santiago's own comparisons on finished roofs in Vietnam.
  • HS code 3925.90.00: Harmonized System Chapter 39 (builders' ware of plastics), as applied in Vietnam's export tariff.
  • Certificates of origin (Form D, AI, AK/VK, AJ/VJ, VC, CPTPP): issued by Vietnam's Ministry of Industry and Trade under the country's free trade agreements.
  • Minimum order of one 40 ft container (about 5,000 m) and about 5 days for production and loading: Santiago export desk, October 2026.

Updated 03/11/2026. Santiago Import Export Co., Ltd, Vietnam. WhatsApp +84 935 391 495 (Mr. Quyen), hotline +84 965 437 316 (Mrs. Ly), email salessantiagoroofing@gmail.com.